Airsoft Smart Control Unit do GB - ver. 2

ASCU is a two-part electronic module (a control unit and a sensor unit) that after installation in the airsoft replicas significantly improves their operation. The traditional switch system has been replaced by the sensor unit that monitors the current position of the sector gear, fire selector and the trigger. The information gathered by this unit is passed on to the control unit – there the software instantly analyzes the data in the processor and controls the replica's motor using a MOSFET active brake.

ASCU improves the operation of a V.2 gearbox and makes the replica comparable with the most expensive and complicated PTW-class replicas.


The ASCU system supervises the operation of the replica regardless of the speed at which the user pulls the trigger. Furthermore, it is also responsible for the full work cycle of the piston, both during semi-automatic fire mode, and continuous fire. After each shot, the piston stops at the starting position.


ASCU has a Low Drain Protection System specially designed to prevent damage to the lithium-polymer (LiPo) batteries.


ASCU prevents the replica from firing once it detects a problem, thereby it protects internal components from sustaining further damage.


ASCU is easy to install in a replica with the v.2 gearbox. Most models do not require modification of the original airsoft gun parts. However, some may require minor and easy to implement modifications, due to which the installation process goes smoothly.

The control unit is very small and may be placed in the buttstock or a gas tube (6.5 cm x 1.6cm x 1.4cm), while the second part of the sensory module replaces completely the components of the original switch assembly and wiring.


The sensor unit monitors the sector gear and thus the entire system is capable of performing complete work cycles of the gearbox, (never shall the BB be left in the barrel once the magazine is removed and spring will never remain in the „ready to shoot” position when the replica is idle).

- The ASCU module is designed to work with other sensors which will not permit firing the replica when the magazine is empty. Moreover, the user will be compelled to use the bolt catch after the exchange of magazines, if he or she uses a replica of the „M” series.

- The system improves the trigger reaction of the AEG replica, which in comparison with the classical system, is virtually instantaneous.

- The unit prevents accidental „double shots”: when the time between first and the following pull of the trigger is quicker than human reaction time - each pull of the trigger results in one shot.

- It also allows you to shoot a three-shot burst by a short pull of the trigger when in continuous fire mode.

- An easy to mount system replaces the switch and antireversal in any given V2 gearbox. The removal of the aforementioned parts completely eliminates the possibility of piston jamming. Moreover, it guarantees that the replica will perform a full cycle every time (the spring will remain in the starting position).

- ASCU controls the battery charge level and prevents excessive discharge, which is crucial when using lithium batteries (LiPo, LiIon, LiFe).

- The module detects problems and defects and signals them by emitting sound and vibration. At the same time, it cuts off the power source, thus preventing more serious damage in the GB.

- This system, by cooperation with the dedicated HU chamber, eliminates blank shots in the replicas with functioning bolt catch, i.e. the shot is impossible if the magazine does not feed BBs.

- ASCU substantially increases the lifetime of the battery.

- It gives more possibilities than Systema Revolution or PTW, at much lower installation cost and allows for the use of a wide range of spare parts available for the standard V2 and V3 gearboxes.

- The product has a 24 month warranty only when it is installed by an authorized tech department.

The ASCU system is CE certified and is compliant with the RoHS directive.


 

Attention!!! ASCU is not compatibile with V2 gearbox by ICS.

MANUAL OF ASCU II - PL

For more details go to: Airsoftsystems.com